|
From: | Chris Kuethe |
Subject: | Re: Newly built / installed gpsd reporting address already in use |
Date: | Wed, 17 Mar 2021 11:07:24 -0700 |
Hello all,
This morning I started a from-scratch installation of gpsd on a rPi3. Brand new install of OS as well.
Distro is latest raspbian which reports to be based on debian 10 (buster)
Uname –r reveals: 5.10.23-v7+ for the kernel
I followed the build instructions which started here:
https://gpsd.io/installation.html (specifically the section for the Raspberry Pi).
I grabbed the tarbal from here: https://download.savannah.gnu.org/releases/gpsd/?C=M&O=D
Choosing gpsd-3.22 dated 09-Jan-2021 02:44
I then followed the build instructions here: https://gpsd.io/building.html
The build went fine without any gating errors.
Upon invoking gpsd (as root) with : “gpsd -N -D3 -F /run/gpsd.sock /dev/ttyUSB0”
(as suggested in the troubleshooting section here: https://gpsd.io/troubleshooting.html)
The following output is produced:
gpsd:WARN: This system has a 32-bit time_t. This gpsd will fail at 2038-01-19T03:14:07Z.
gpsd:INFO: launching (Version 3.22)
gpsd:ERROR: can't bind to IPv4 port gpsd, Address already in use
gpsd:ERROR: maybe gpsd is already running!
gpsd:ERROR: can't bind to IPv6 port gpsd, Address already in use
gpsd:ERROR: maybe gpsd is already running!
gpsd:ERROR: command sockets creation failed, netlib errors -1, -1
I verified before invoking the above command that there was no /run/gpsd.sock file
I also verified I can see and talk to the gps using: “gpsmon /dev/ttyUSB0”
Any ideas for me to try?
Samuel Joshua Stein (Josh) – Principal Research Engineer
Argonne Special Projects – Material Science Division
Argonne National Laboratory
9700 S. Cass Ave, Argonne IL 60439
(630) 252-4105
[Prev in Thread] | Current Thread | [Next in Thread] |