Re: [Discuss-gnuradio] Split-function implementation of 802.11g OFDM PHY and MAC on USRP2

[Nemanja Trecakov]

> >
> > Sorry, I tried the command 'gmake'(not 'gnumake') in command promt while in 
> > top\usrp2 folder in order to build the image.
> > Is this the correct way to run gnumake?
> >
>
> On linux, i type "make proj" in the top level directory to make the ise
> project file. I'm not sure what the binary is called when you install
> gnumake. What files were installed on you system? Best guesses: make,
> gmake, or gnumake
>
> -josh

1) When I installed gnumake, I got a binary in C:\Program Files\GnuWin32\bin 
called 'make'. However, when I write 'make' in the command promt, I get this:

C:\USRP2_fpga_NEMO\usrp2\top\USRP2>make
'make' is not recognized as an internal or external command,
operable program or batch file.


2) I have tried again with 'gmake' command to make project, but I get the same 
error as before - 'head' is not recognized and no rule to make target.

C:\USRP2_fpga_NEMO\usrp2\top\USRP2>gmake proj
'head' is not recognized as an internal or external command,
operable program or batch file.
gmake: *** No rule to make target `C:/USRP2_fpga_NEMO/usrp2/top/USRP2/C:/USRP2_f
pga_NEMO/usrp2/fifo/buffer_int.v', needed by `C:/USRP2_fpga_NEMO/usrp2/top/USRP2
/build/u2_rev3.xise'.  Stop.


Do you have any suggestions?