ok,
Once in a while the ccscript Dial command exit just after
trunkStep(TRUNK_STEP_DIALXFER)
However it does not reach dialHandler since I have put some break point
in it to confirm.
I guess I will have to dig ccscript, do you have any recommendation or
hint?
fifo: cmd=start trunk1 joinrec session.parent=-066-1131907070
callerid=5145912207 calledid=5148271251
dx(0): attach script
dx(0): dx_stopch()
dx(0): step 3 set(%number,%callerid)
dx(0): step 3 if(%callerid,.eq.,UNKNOWN,then)
dx(0): step 3 set.size(512,%dbquery)
dx(0): step 3 slog(<---, JoinRec Dialing calledid:,%calledid, ,--->)
dx(0): joinrec: <--- JoinRec Dialing calledid:5148271251 --->
dx(0): step 3 dial(=maxTime,999999,%calledid)
dx(0): script exiting
dx(0): HANGUP TRUNK_ENTER_STATE reset_timer:139298675 hangup_timer:100
dx(0): hangup
dx(0): dx_stopch()
dx(0): IDLE TRUNK_ENTER_STATE HDL:3 CRN:-1
dx(0): idle
-----Original Message-----
From: David Sugar [mailto:address@hidden
Sent: November 11, 2005 3:43 PM
To: Julien Chavanton
Cc: mailing_list_bayonne-devel
Subject: Re: [Bayonne-devel] iso images for Bayonne packages...
That is because it jumps to a new state through either
TRUNK_STEP_SOFTDIAL or TRUNK_STEP_DIALXFER. Anytime I jump to new
state, I always return false from a scrXXX handler so that the ccscript
engine does not try to multi-step execute. When the new state completes
it advances the engine, which is why I do not advance here either.
Hence, return true/false is being used in the scripting engine for
scrXXX handlers not in terms of error, but in terms of indicating
execution behavior. This is true in ccscript3 as well, where there are
further automatic options to execute scripted code blocks quickly. That
is part of why Bayonne2 often "seems" to run scripts faster than
bayonne1 on low port density systems, although clever use of begin in
bayonne1 scripting can achieve similar results.
Julien Chavanton wrote:
Hi David,
Looking at Bayonne 1.2.14
server/scrDial: "return true;" as been commented, and sometimes the
dial
command exit the script?
I guess it shall return true if everything went well?
// advance();
// return true;
if(soft)
trunkStep(TRUNK_STEP_SOFTDIAL);
else
trunkStep(TRUNK_STEP_DIALXFER);
return false;
_______________________________________________
Bayonne-devel mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/bayonne-devel
_______________________________________________
Bayonne-devel mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/bayonne-devel