Hi,
I am back from the field, today no water, nowind....This month in
south of france it is an GOOD day!
I ha have move the quad to NAV :
takeof with the mouse
up to 5more meter with mouse,
mow down 5meters with the mouse,
flare nice with slow down fly upto ground.
The circuit from home, P1,P2,home... is almost clean.
Why almost? , The quad move to P1 and it stay at 1 or 2 meters to
P1, and try too gently to find it, if I move(with mouse) P1 on the
quad, it fly to P2......the same in P2
The translation is very slow...
After the travel fly, a automatique flare... about 1 meter error
from the takeoof point (les than the GPS precision)
Please is it possible to manage more agressive fly to point, or to
manage the "size of the point", to define 1,2,3 meters error to
accepte it?
Where is it possible to setup a higger flyspeed when the quad move
to way point?
Next days, higger wind... could be better for test.... or crash....
Best regards,
Eric
Le 02/11/2011 17:53, Eric BAHIER a écrit :
hi,
I will move to NAV, and I'll define only one stand-by point.... In
this case th AP_MODE_Failsafe will be applicable, and efficient..
Thanks,
Eric
Le 02/11/2011 17:45, Gautier Hattenberger a écrit :
Hi,
There is no "almost" nav mode. Being in nav mode means that you
are using the flight plans instructions to fly. If you really
want to only hover while being in this mode, you can just make a
flight plan that waits for the gps and then saty at a given
waypoint.
Also the horizontal control loops in hover and nav mode are
slightly different, so if you tune in hover, your flight in nav
may not be as good. So if your goal is to flight in nav mode,
trim it in this mode. If you want to fly manually and hover from
time to time, trim using hover mode.
Gautier
On 02/11/2011 16:53, Eric BAHIER wrote:
hi felix,
In my understand, the failsafe mode began active when we lost
GPS or lost Radio, in NAV-MODE
I read it on :"http://paparazzi.enac.fr/wiki/Rotorcraft_Configuration#Autopilot_modes",
your link :
- AP_MODE_FAILSAFE
-
This is a failsafe mode that gets triggered if:
- RC signal is lost (and you are not in KILL or NAV mode)
- GPS and RC is lost in NAV mode
I can accept, AP_MODE_HOVER_DIRECT and AP_MODE_HOVER_Z_HOLD
are not realy in NAV mode, but "almost nav mode".
For my test I want first to have AP_MODE_HOVER_Z_HOLD full
opperational up to ????xx km/h wind, and move to NAV when the
stationair(GPS) fly is done.
how to, to triggered the AP_MODE_FAILSAFE , for my understand,
this setup is indépendant from manual/auto1/auto2....I
missuterstand?
regards,
Eric
The autopilot will level the rotorcraft out (setpoints to
zero pitch and roll angles) and descend at 0.5m/s downwards.
Le 02/11/2011 14:29, Eric BAHIER a écrit :
Hi,
I woulds like to use "AP_MODE_FAILSAFE ".
Currently I use :
<section name="MODE">
<define name="MANUAL" value="AP_MODE_ATTITUDE_DIRECT"
/>
<define name="AUTO1" value="AP_MODE_HOVER_DIRECT" />
<define name="AUTO2" value="AP_MODE_HOVER_Z_HOLD" />
</section>
I would like to have "AP_MODE_FAILSAFE" active in HOVERs
mode, is it possible?
I probably lost the GPS some time in HOVER.... and the quad
go away...where it can.... If is stay and land it could be
nice for debuging.
Where, how to... I will proced to use "AP_MODE_FAILSAFE"....
Thanks,
eric
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
--
************************************
Lez Concept EURL
Eric BAHIER
15 chemin neuf
34 980 Montferrier sur LEZ
France
Tel : 33 4 67 59 92 53
Fax : 33 9 59 15 92 53
************************************
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
--
************************************
Lez Concept EURL
Eric BAHIER
15 chemin neuf
34 980 Montferrier sur LEZ
France
Tel : 33 4 67 59 92 53
Fax : 33 9 59 15 92 53
************************************
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
--
************************************
Lez Concept EURL
Eric BAHIER
15 chemin neuf
34 980 Montferrier sur LEZ
France
Tel : 33 4 67 59 92 53
Fax : 33 9 59 15 92 53
************************************
|