On Thu, May 20, 2010 at 9:29 PM, Smith L.
<address@hidden> wrote:
Hi Colby,
Were you able to communicate between two USRP2s using bbn 80211
usrp2_version code?
I am not able to receive packets using USRP2 receiver even when other USRP2
is transmitting. Can you please let me know if there are any changes
required to be made in the usrp2_version code or any specific command line
parameters to make this work (i.e. to receive 80211b packets with USRP2 with
another USRP2 transmitting).
Currently, I can only receive beacons from nearby access points using USRP2.
Not an answer to your questions... but another project to suggest:
https://www.cgran.org/wiki/SPAN80211bThey had pretty good luck at receiving 802.11b transmissions on USRP1 by putting the despreading in the FPGA. No transmit code though from what I remember.
- George