Re: [avrdude-dev] stk500 and firmware 1.14

[Brian Dean]

On Thu, Feb 20, 2003 at 08:50:49AM -0800, Theodore A. Roth wrote:

> This doesn't make sense. hiv is not an option when parallel
> programming since you _must_ take reset to 12V in order for the device
> to switch into parallel programming mode.

In the "set device" command, what is the distinction between a device
that supports full parallel mode vs pseudo parallel mode - the
'parmode' parameter to the "set device" command (buf[4] in avrdude)?
Vales of 'yes' and 'no' don't seem to be sufficent to describe the
parallel programming capabilities.  What is "psuedo" parallel
programming support mean?

-Brian