Re: [Paparazzi-devel] imu sensor filtering?

[Chris]

Ok i got it, i will go at it this monday because i am waiting for new 
materials
as my experiments consumed a lot of pads (you know cut and move pads around)
and i am almost out of pad material.
There is always room for improvement which is much needed in my case.
Thank you very much Chris for the info....

"Are you using GAS/GLOW engine ?"
Correct, i am using a Saito FG57T 57cc 4 stroke twin cylinder gasoline 
engine.
I never had any problems with electrics or turbine powered airplanes but 
this is a different beast.
It can tear apart the fuselage especially if you run it at full throttle 
without the wings attached.
At idle you can see the tail vibrating more than 2cm...
Chris


On 05/24/2013 07:00 PM, address@hidden wrote:
> The CG is on a lever above the plane of the dampeners. If you don't have room 
> for another mass on a lever bellow, then you could: