|
From: | Jochen Rieger |
Subject: | Re: [Paparazzi-devel] PPM Encoder and Lisa/L |
Date: | Wed, 23 Nov 2011 09:37:19 +0100 |
Hi Jochen,The picture seems to be missing. I would love to see how you did this because I will trying to do much the same thing in the next days.ThanksSimonOn Wed, Nov 23, 2011 at 9:07 AM, Jochen Rieger <address@hidden> wrote:
I fixed the problem. When you want use PPM input at Trig.pin 01 (UART1) then you must solder a bridge (0 Ohm) at the place, which is shown at the attached picture.2011/11/21 Jochen Rieger <address@hidden>
Hmmm should be 100 Ohm? I dont see them, in wiki the picture there is also not a resistor, i believe.
I marked the place in the attached picture, i think there should maybe the resistor for PIN1 of UART1.
-Jochen
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
[Prev in Thread] | Current Thread | [Next in Thread] |