paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM Encoder and Lisa/L


From: Jochen Rieger
Subject: Re: [Paparazzi-devel] PPM Encoder and Lisa/L
Date: Wed, 23 Nov 2011 09:07:09 +0100

I fixed the problem. When you want use PPM input at Trig.pin 01 (UART1) then you must solder a bridge (0 Ohm) at the place, which is shown at the attached picture.

2011/11/21 Jochen Rieger <address@hidden>
Hmmm should be 100 Ohm? I dont see them, in wiki the picture there is also not a resistor, i believe.

I marked the place in the attached picture, i think there should maybe the resistor for PIN1 of UART1.

-Jochen




reply via email to

[Prev in Thread] Current Thread [Next in Thread]