paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM Encoder and Lisa/L


From: Simon Wilks
Subject: Re: [Paparazzi-devel] PPM Encoder and Lisa/L
Date: Wed, 23 Nov 2011 11:15:11 +0100

It's a bit hard to see detail in the picture. Could you explain in a bit more detail exactly where are you actually soldering the wire? 

Thanks

Simon

On Wed, Nov 23, 2011 at 10:05 AM, Christophe De Wagter <address@hidden> wrote:
can you please upload that also to the wiki page http://paparazzi.enac.fr/wiki/User/LisaL under a new PPM Remote receiver paragraph at the bottom?

-Christophe 




On Wed, Nov 23, 2011 at 9:37 AM, Jochen Rieger <address@hidden> wrote:
Oh, sorry.

I solder a litz wire, as a bridge.

The picture:

http://www.fotos-hochladen.net/view/lisalv11topli4thyrqkz.png

Regards.
Jochen


2011/11/23 Simon Wilks <address@hidden>
Hi Jochen,

The picture seems to be missing. I would love to see how you did this because I will trying to do much the same thing in the next days.

Thanks

Simon

On Wed, Nov 23, 2011 at 9:07 AM, Jochen Rieger <address@hidden> wrote:
I fixed the problem. When you want use PPM input at Trig.pin 01 (UART1) then you must solder a bridge (0 Ohm) at the place, which is shown at the attached picture.

2011/11/21 Jochen Rieger <address@hidden>
Hmmm should be 100 Ohm? I dont see them, in wiki the picture there is also not a resistor, i believe.

I marked the place in the attached picture, i think there should maybe the resistor for PIN1 of UART1.

-Jochen




_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



reply via email to

[Prev in Thread] Current Thread [Next in Thread]