Re: [Paparazzi-devel] ADC channel for Gyro

[David Conger]

Hello,

Thank you Michel. GTK. Can I ask a question related...

My Gyro is 5v (ADXRS300) with ST1, ST2, TEMP, 2.5V, RATE, GND, 5V..

Can someone please give the pins to connect to the Tiny on ADC2? 

5v is easy -> +5v on Tiny

GND -> GND on Tiny

....

Without any instructions on the Wiki about the connector and going by the funjet1.xml airframe file given I had it connected to ADC1 

GRYO ---- TINY

GND -> GND

RATE->ADC3

5V->+5v 

I hope I didn't damage ADC1 on the Tiny

Thank you,

-David

So, if I were to connect my 5v Gyro into 

On Jun 23, 2008, at 8:29 AM, Michel GORRAZ wrote:

Hi,
For sure, you can use this ADC with a Gyro (or  other analog sensor) but this is a 3.3v max input level, so if your gyro  is a 5v, don't forget the resistor bridge...or use  ADC5 or ADC6 : these inputs have their own on-board resistor bridge.

@+
Michel

2008/6/23 C Kuo <address@hidden>:

Hi guys


 I was wondering, on the "USB" port on TinyV2 has a ADC_7, could I use this
chaneel for connecting roll gyro?





Thanks

                                                                Chen


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel