RE: [Nel] STL-Port

[Jacob Rohde]

Ok, I have downloaded STLPort since that seems to be the way to got. I could not make the 4.5 version (which NeL requires) with my VC7.1 compiler. Therefore I used the newer version 4.6. Would that be a problem you reckon?

 

And thanks for your reply J

 

Jacob

 

---

From: address@hidden [mailto:address@hidden On Behalf Of Ben Woodhead
Sent: 3. februar 2004 16:26
To: Developer's list for the NeL platform
Subject: Re: [Nel] STL-Port

 

Hello,

 

The answer is of course Yes and No.. :) Don't you just love that.

 

You are correct, vc7.1 is pretty much compliant and doesn't suffer from any of the problems it did with 6 (and possible 7.0) but stl-port takes some additional setup code to use it. When I ported Nel to 7.0 I had trouble removing the stl-port dependancies. Since I had stlport on my computer I didn't bother removing it. :)

 

There is a macro to define if you are using .net. You are more then welcome to create a patch without stl-port but as far as I have heard noone has done this yet. I would but I had a physical drive failure the other day and all of my cds are on the other side of the country so I don't have .net or 2003.

 

Ben

address@hidden

----- Original Message -----

From: Jacob Rohde

To: address@hidden

Sent: Tuesday, February 03, 2004 11:03 AM

Subject: [Nel] STL-Port

 

I have downloaded the NeL source-tree.

 

At the moment I am looking through the code etc. In the INSTALL file it says you need STLPort to compile

 Is that also the case if using version 7.1 of the VC++ compiler (which should be pretty much standard compliant)? I’m asking because I have experienced some projects in which the STLPort is only needed if you use version 6.

---

_______________________________________________
Nel mailing list
address@hidden
http://mail.nongnu.org/mailman/listinfo/nel-all