[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Question] gpsd, ntrip & C94-M8P (u-Blox)

From: Gary E. Miller
Subject: Re: [Question] gpsd, ntrip & C94-M8P (u-Blox)
Date: Thu, 14 May 2020 10:07:50 -0700

Yo Florian!

On Thu, 14 May 2020 09:27:33 +0200
Florian Kiera <address@hidden> wrote:

> >> Everything got wiped :/  
> > Yup.  How did you do that?  
> I don't know how. :/ It gave out RTCM3 messages (gpspipe -w) until I 
> used the ubxtool

Then start all over.  Reset your receiver to factory defaults, then
write a script to do you config one item at a time.

No one can't fix what you forgot you did.

> >>> What are you sending to with ubxtool that is not doing what you
> >>> think it should?  
> >> As described below, I just used "gpsd -n /dev/ttyACM0" to get a
> >> running gpsd and than used the ubxtool command "ubxtool -p STATUS
> >> -p CONFIG -P 20.30".  
> > Yes, but what did you do before that to enable RTCM3 out from the
> > base and start the survey-in?  
> Used u-center to configure UBX-CFG-PRT and UBX-CFG-TM3 to RTCM3 out
> and survey-in. Types of RTCM3 messages that are needed were
> configured on UBX-CFG-MSG (1005, 1077, 1087, 1230)

As I've said before: I don't run windows, so I can't run u-center.

If you do not want to configure with ubxtool, then you are on your own.

> >> RTCM3 messages have been turned off and protocol out has been
> >> modified, as well as the dynModel  
> > Yes, why/how did you do that?  
> Ubxtool -p STATUS -p CONFIG -P 20.30

That reads, not writes.  So not possible that turned off anything.

> >> All this appeared after using "ubxtool -p STATUS -p CONFIG -P
> >> 20.30"  
> > No, that is when you discovered it.  
> I haven't changed anything... neither with u-center nor with the
> ubxtool itself (which I don't even know how to use properly to setup 
> configurations).
> All I did was setting up gpsd to connect to the port and use ubxtool 
> status/config output.

I can't help you if you do not use ubxtool.

> >> since even parsing it with grep
> >> ended up in a huge mess  
> > I can't comment on messes you make without seeing how you did it.  
> Just ran "ubxtool -p STATUS -p CONFIG -P 20.30"... Since its hard to 
> believe I will send just a quick summary of my console log.

Summaries are not useful.  My mind reading and remote devination is
not strong enough.  Full output, or do not bother.

Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
        address@hidden  Tel:+1 541 382 8588

            Veritas liberabit vos. -- Quid est veritas?
    "If you can't measure it, you can't improve it." - Lord Kelvin

Attachment: pgpMyl4RaPmJi.pgp
Description: OpenPGP digital signature

reply via email to

[Prev in Thread] Current Thread [Next in Thread]