[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Question] gpsd, ntrip & C94-M8P (u-Blox)

From: Gary E. Miller
Subject: Re: [Question] gpsd, ntrip & C94-M8P (u-Blox)
Date: Fri, 15 May 2020 10:00:45 -0700

Yo Florian!

You have reached my loop count limit.  you say, I say, you say, I say,
you say, with no new info.

I'll skip this thread until there is new info.

On Fri, 15 May 2020 11:21:16 +0200
Florian Kiera <address@hidden> wrote:

> Hey Gary!
> Am 14.05.20 um 19:07 schrieb Gary E. Miller:
> > Yo Florian!
> >
> > On Thu, 14 May 2020 09:27:33 +0200
> > Florian Kiera <address@hidden> wrote:
> >
> >  
> >>>> RTCM3 messages have been turned off and protocol out has been
> >>>> modified, as well as the dynModel  
> >>> Yes, why/how did you do that?  
> >> Ubxtool -p STATUS -p CONFIG -P 20.30  
> > That reads, not writes.  So not possible that turned off anything.  
> Obviously it does write over the protocol out (UBX-CFG-PRT). I will
> send another console output. (attachment) It even proofs that ubxtool
> got 2 different config outputs ("although its only pulling").
> I cannot tell (simply don't know) what else could cause it. All I am 
> certain of AND which I can proof is that ubxtool changed the protocol 
> out from RTCM3 to UBX (check UBX-CFG-PRT).
> Sadly (which is actually good) dynModel didn't changed here.
> >>> I can't comment on messes you make without seeing how you did it.
> >>>  
> >> Just ran "ubxtool -p STATUS -p CONFIG -P 20.30"... Since its hard
> >> to believe I will send just a quick summary of my console log.  
> > Summaries are not useful.  My mind reading and remote devination is
> > not strong enough.  Full output, or do not bother.  
> I don't know what you are up to here. I sent the console log of all
> what I did. Thats what made me believe ubxtool did not what it
> supposed to do there (ubxtool_does_something.txt).
> ubxtool aside and thinking of dynModel and RTCM3 messages beeing
> given out back to my actual question:
> My base sends RTCM3 messages and gpsd on the rover end is receiving
> them and provides them to my M8P (rover side). How is it not changing
> to RTK Float/Fix but to DGPS if all that is needed for RTK status are
> RTCM3 messages?
> Regards Florian

Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
        address@hidden  Tel:+1 541 382 8588

            Veritas liberabit vos. -- Quid est veritas?
    "If you can't measure it, you can't improve it." - Lord Kelvin

Attachment: pgpcSOkSjTdUO.pgp
Description: OpenPGP digital signature

reply via email to

[Prev in Thread] Current Thread [Next in Thread]