Re: [fluid-dev] Switching tunings

[Srijan Deshpande]

Thank you, but I'm confused - does fluidsynth recognise the Single-note tuning change sysex? And how do I get it to switch to exactly the tuning file I want to use?

 

---------- Forwarded message ----------
From: Srijan Deshpande <address@hidden>
To: address@hidden
Cc: 
Date: Tue, 15 Sep 2015 21:42:55 +0530
Subject: [fluid-dev] Switching tunings

Hello,

I'm trying to figure out how to switch tunings in Fluidsynth using control change / program change messages. 

I've generated fluidsynth tuning files using scala and I'm able to load these using the -f flag. I'm also able to switch between tunings from the fluidsynth command line using 'settuning' (eg: settuning 0 0 0 ; settuning 0 0 1).

My question is, how do I do this from my MIDI controller? Sending Bank/Program change messages does not seem to work.

Any ideas?

Thanks,

Srijan

---------- Forwarded message ----------
From: "R.L. Horn" <address@hidden>
To: FluidSynth mailing list <address@hidden>
Cc: 
Date: Tue, 15 Sep 2015 12:08:00 -0500 (CDT)
Subject: Re: [fluid-dev] Switching tunings
On Tue, 15 Sep 2015, Srijan Deshpande wrote:

I'm trying to figure out how to switch tunings in Fluidsynth using control change / program change messages.

My question is, how do I do this from my MIDI controller? Sending Bank/Program change messages does not seem to work.

The equivalent, more of less, of tuning/tune/settuning is the Single-note Tuning Change (real-time) sysex.  See:

  http://www.midi.org/techspecs/midituning.php

Some of the other tuning-change commands might work also, but the commonly utilized Bulk Tuning Dump doesn't (and, apparently, shouldn't, though the specification contradicts itself on the subject).



_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev