Re: [Discuss-gnuradio] Re: USRP2 current svn code not working. Is the svn code still in flux?

[Eric Blossom]

On Sun, Oct 26, 2008 at 09:49:07PM +0100, Martin DvH wrote:
> 
> On Sun, 2008-10-26 at 10:09 -0700, Johnathan Corgan wrote:
> > On Sun, Oct 26, 2008 at 8:33 AM, Johnathan Corgan
> > <address@hidden> wrote:
> > 
> > > Also, I suspect that there might be a compatibility issue between the
> > > version of the FPGA code that was shipped on the SD card and the current
> > > trunk firmware/host code.
> > 
> > This has been confirmed (thanks Martin).
> The new fpga image in combination with the latest svn code also makes it 
> possible to set the gain from the gui of usrp2_fft.py without crashing the 
> app.
> (And the gain actually changes as can be seen by the change in signal
> level)
> 
> Trying to set the frequency this way is not fixed. This still hangs the
> whole app.
> 
> Greetings,
> Martin

Thanks for the data point, Martin.

I'll take a look at this a bit later on today.

Eric