Re: [Discuss-gnuradio] Re: USRP2 current svn code not working. Is the svn code still in flux?

[Johnathan Corgan]

On Sun, 2008-10-26 at 21:49 +0100, Martin DvH wrote:

> The new fpga image in combination with the latest svn code also makes it 
> possible to set the gain from the gui of usrp2_fft.py without crashing the 
> app.
> (And the gain actually changes as can be seen by the change in signal
> level)
> 
> Trying to set the frequency this way is not fixed. This still hangs the
> whole app.

I've updated usrp2_fft.py on the trunk to use the latest gr-usrp2.  It
is working normally now with setting the USRP2 parameters via the
command line, however, as you note, changing frequency doesn't work.
This has been isolated to some problem in either libusrp2 or in the
USRP2 firmware.  Eric and I are working on this.

Other commands that operate in "batch" mode, where you set the USRP2
parameters from the command line, are working normally now as well.

Thanks again for your testing.

-Johnathan