[PULL 20/88] xive/kvm: Trigger interrupts from userspace

[David Gibson]

From: Greg Kurz <address@hidden>

When using the XIVE KVM device, the trigger page is directly accessible
in QEMU. Unlike with XICS, no need to ask KVM to fire the interrupt. A
simple store on the trigger page does the job.

Just call xive_esb_trigger().

This may improve performance of emulated devices that go through
qemu_set_irq(), eg. virtio devices created with ioeventfd=off or
configured by the guest to use LSI interrupts, which aren't really
recommended setups.

Signed-off-by: Greg Kurz <address@hidden>
Message-Id: <address@hidden>
Reviewed-by: Cédric Le Goater <address@hidden>
Signed-off-by: David Gibson <address@hidden>
---
 hw/intc/spapr_xive_kvm.c | 16 ++--------------
 1 file changed, 2 insertions(+), 14 deletions(-)

diff --git a/hw/intc/spapr_xive_kvm.c b/hw/intc/spapr_xive_kvm.c
index 08012ac7cd..69e73552f1 100644
--- a/hw/intc/spapr_xive_kvm.c
+++ b/hw/intc/spapr_xive_kvm.c
@@ -354,32 +354,20 @@ static void kvmppc_xive_source_get_state(XiveSource *xsrc)
 void kvmppc_xive_source_set_irq(void *opaque, int srcno, int val)
 {
     XiveSource *xsrc = opaque;
-    SpaprXive *xive = SPAPR_XIVE(xsrc->xive);
-    struct kvm_irq_level args;
-    int rc;
-
-    /* The KVM XIVE device should be in use */
-    assert(xive->fd != -1);
 
-    args.irq = srcno;
     if (!xive_source_irq_is_lsi(xsrc, srcno)) {
         if (!val) {
             return;
         }
-        args.level = KVM_INTERRUPT_SET;
     } else {
         if (val) {
             xsrc->status[srcno] |= XIVE_STATUS_ASSERTED;
-            args.level = KVM_INTERRUPT_SET_LEVEL;
         } else {
             xsrc->status[srcno] &= ~XIVE_STATUS_ASSERTED;
-            args.level = KVM_INTERRUPT_UNSET;
         }
     }
-    rc = kvm_vm_ioctl(kvm_state, KVM_IRQ_LINE, &args);
-    if (rc < 0) {
-        error_report("XIVE: kvm_irq_line() failed : %s", strerror(errno));
-    }
+
+    xive_esb_trigger(xsrc, srcno);
 }
 
 /*
-- 
2.23.0