[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-discuss] Host-Bridge in routed TAP Mode

From: Sven Gehr
Subject: Re: [Qemu-discuss] Host-Bridge in routed TAP Mode
Date: Thu, 26 Sep 2013 17:46:36 +0200
User-agent: KMail/4.11.1 (Linux/3.7.10-1.16-desktop; KDE/4.11.1; x86_64; ; )

Am Mittwoch, 25. September 2013, 10:30:15 schrieb Vlad Yasevich:

>  From what I understand, routed mode is just that.  It depends
> on ip forwarding being enabled for the interfaces and it will
> try to route the packets from your bridge out through your designated
> interface.

Exactly, all packets from/to the bridging should be routed to the interface 

> What you seem to be looking for is a bridged configuration where
> you connect the physical nic and virtial nic to the same bridge.

I can not say exactly. I think my problem is that the physical interface is 
not connected to the bridge. I recognize the fact that everything works if 
I'll add it manually with:

brctl addif intern eth0

> I don't see libvirt support that in their virtual network config.

I do not understand. How do I add libvirt support in my configuration?

> You can used libvirt to setup a bridged interface in the Network 
> Interfaces tab though.

I have no graphical interface on the system. What is missing in my xml-file?

sorry for my english, I do my best with google-translater :-(

Viele GrĂ¼sse

Sven Gehr

reply via email to

[Prev in Thread] Current Thread [Next in Thread]