[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining devic
From: |
Michael S. Tsirkin |
Subject: |
Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space |
Date: |
Wed, 27 Mar 2019 11:32:55 -0400 |
On Tue, Mar 26, 2019 at 04:55:19PM -0600, Alex Williamson wrote:
> Conventional PCI buses pre-date requester IDs. An IOMMU cannot
> distinguish by devfn & bus between devices in a conventional PCI
> topology and therefore we cannot assign them separate AddressSpaces.
> By taking this requester ID aliasing into account, QEMU better matches
> the bare metal behavior and restrictions, and enables shared
> AddressSpace configurations that are otherwise not possible with
> guest IOMMU support.
>
> For the latter case, given any example where an IOMMU group on the
> host includes multiple devices:
>
> $ ls /sys/kernel/iommu_groups/1/devices/
> 0000:00:01.0 0000:01:00.0 0000:01:00.1
>
> If we incorporate a vIOMMU into the VM configuration, we're restricted
> that we can only assign one of the endpoints to the guest because a
> second endpoint will attempt to use a different AddressSpace. VFIO
> only supports IOMMU group level granularity at the container level,
> preventing this second endpoint from being assigned:
>
> qemu-system-x86_64 -machine q35... \
> -device intel-iommu,intremap=on \
> -device pcie-root-port,addr=1e.0,id=pcie.1 \
> -device vfio-pci,host=1:00.0,bus=pcie.1,addr=0.0,multifunction=on \
> -device vfio-pci,host=1:00.1,bus=pcie.1,addr=0.1
>
> qemu-system-x86_64: -device vfio-pci,host=1:00.1,bus=pcie.1,addr=0.1: vfio \
> 0000:01:00.1: group 1 used in multiple address spaces
>
> However, when QEMU incorporates proper aliasing, we can make use of a
> PCIe-to-PCI bridge to mask the requester ID, resulting in a hack that
> provides the downstream devices with the same AddressSpace, ex:
>
> qemu-system-x86_64 -machine q35... \
> -device intel-iommu,intremap=on \
> -device pcie-pci-bridge,addr=1e.0,id=pci.1 \
> -device vfio-pci,host=1:00.0,bus=pci.1,addr=1.0,multifunction=on \
> -device vfio-pci,host=1:00.1,bus=pci.1,addr=1.1
This will break extended address space access though, won't it?
things like attempts to take PCI Express badnwidth into
consideration by drivers for E2E credit math will also
not work ...
>
> While the utility of this hack may be limited, this AddressSpace
> aliasing is the correct behavior for QEMU to emulate bare metal.
This one's a valid point.
> Signed-off-by: Alex Williamson <address@hidden>
> ---
> hw/pci/pci.c | 33 +++++++++++++++++++++++++++++++--
> 1 file changed, 31 insertions(+), 2 deletions(-)
>
> diff --git a/hw/pci/pci.c b/hw/pci/pci.c
> index 35451c1e9987..38467e676f1f 100644
> --- a/hw/pci/pci.c
> +++ b/hw/pci/pci.c
> @@ -2594,12 +2594,41 @@ AddressSpace
> *pci_device_iommu_address_space(PCIDevice *dev)
> {
> PCIBus *bus = pci_get_bus(dev);
> PCIBus *iommu_bus = bus;
> + uint8_t devfn = dev->devfn;
>
> while(iommu_bus && !iommu_bus->iommu_fn && iommu_bus->parent_dev) {
> - iommu_bus = pci_get_bus(iommu_bus->parent_dev);
> + PCIBus *parent_bus = pci_get_bus(iommu_bus->parent_dev);
> +
> + /*
> + * Determine which requester ID alias should be used for the device
> + * based on the PCI topology. There are no requester IDs on
> convetional
> + * PCI buses, therefore we push the alias up to the parent on each
> non-
> + * express bus. Which alias we use depends on whether this is a
> legacy
> + * PCI bridge or PCIe-to-PCI/X bridge as in chapter 2.3 of the
> PCIe-to-
> + * PCI bridge spec. Note that we cannot use pci_requester_id() here
> + * because the resulting BDF depends on the secondary bridge register
> + * programming.
Could you clarify this part a bit pls?
> We also cannot lookup the PCIBus from the bus number
> + * at this point for the iommu_fn. Also, requester_id_cache is the
> + * alias to the root bus, which is usually, but not necessarily
> always
> + * where we'll find our iommu_fn.
> + */
> + if (!pci_bus_is_express(iommu_bus)) {
> + PCIDevice *parent = iommu_bus->parent_dev;
> +
> + if (pci_is_express(parent) &&
> + pcie_cap_get_type(parent) == PCI_EXP_TYPE_PCI_BRIDGE) {
> + devfn = PCI_DEVFN(0, 0);
Why 0,0?
> + bus = iommu_bus;
> + } else {
> + devfn = parent->devfn;
> + bus = parent_bus;
> + }
> + }
> +
> + iommu_bus = parent_bus;
> }
> if (iommu_bus && iommu_bus->iommu_fn) {
> - return iommu_bus->iommu_fn(bus, iommu_bus->iommu_opaque, dev->devfn);
> + return iommu_bus->iommu_fn(bus, iommu_bus->iommu_opaque, devfn);
> }
> return &address_space_memory;
> }
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, (continued)
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Alex Williamson, 2019/03/27
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Peter Xu, 2019/03/27
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Auger Eric, 2019/03/28
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Robin Murphy, 2019/03/28
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Auger Eric, 2019/03/28
- Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Robin Murphy, 2019/03/28
Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Auger Eric, 2019/03/27
Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space,
Michael S. Tsirkin <=
Re: [Qemu-devel] [RFC PATCH] pci: Use PCI aliases when determining device IOMMU address space, Alex Williamson, 2019/03/29