Re: [Qemu-devel] How to modify configure for new added file

[Kaiyuan]

I am so sorry for my abrupt mail. I am newbie to open source communities.My 
study is to add a new encrypt module to PowerPC boards.  But I think the ways 
to add HW device are same between ARM or PowerPC. So I found out some similar 
implementation like your commit. But the contents about configure confuse me. 
How to let make to know there is new files added to project?


Kaiyuan Liang

In 2014-10-29，Peter Crosthwaite <address@hidden> wrote:-----Origin email-----
 From: Peter Crosthwaite <address@hidden>
 Sent Time: Wednesday, October 29, 2014
 To: Kaiyuan <address@hidden>
 Subject: RE: How to modify configure for new added file

Hi Kaiyuan,
 
I suggest asking these questions on the qemu-devel mailing list, even if you do 
target them at a specific person.
 
The best way to ask is:
 
“Hi everyone…”
 
But then if you have particular people in mind who you think can best answer 
your question you add them to the email to: or cc: .
 
Some other information you may wish to include is what qemu target or targets 
you are running for? is this ARM?
 
Regards,
Peter
 
From: Kaiyuan [mailto:address@hidden
 Sent: Wednesday, October 29, 2014 3:04 PM
 To: Peter Crosthwaite
 Subject: How to modify configure for new added file


 

Hello, Peter

 

I am working on adding a new device to hw/misc/*. One problem I meet is how to 
modify relevant configure file to make my new file can be compiled into whole 
project. I check out other commit and see that you add new timer a9gtimer to 
hw/timer/* in commit c21c3b53e122a807ae4f5443b7f74f3850f21e37 . I diff your 
commit, but still don't understand how to do it. Could you give me some 
suggestions? 

 

Thanks,

Kaiyuan Liang