[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Paparazzi-devel] Unable to detect the USB device
From: |
C Kuo |
Subject: |
Re: [Paparazzi-devel] Unable to detect the USB device |
Date: |
Sat, 7 Jun 2008 17:43:24 +0100 |
User-agent: |
Internet Messaging Program (IMP) 3.2.2 |
Hi there
My step is abit strange, but anyway, I let you know.
First, I install the phlips flash software on the winxp (which you can find
the link for the software on the wiki).
Second, from there, I use the FTDI cable to connect from winxp to tiny1.1
(note, you must install the driver for FTDI cable). once power up the board,
the click on the "read device" in the phlips flash software. If your board is
ok, then it will show the chip you have is LPC2148, if the board is not ok,
then it will tell you error.
Third, when the board had problem, I tend to check on the power first, because
they are always the problem (especially check the 5V output from Tiny1.1).
After the power is checked, I then check the connection of each pin on the chip
by use digital meter (just check the connectivity), and extra care should be
taken when checking at the connection to the crystal.
Forth, once everything is checked, connect back on, try to read the device
again, hopefully, it will read it. from here, you can either upload the
bootloader from winxp (provide that you have the hex file), or you can follow
all the step from the wiki to install bootloader and flash the program to it.
Hope these will help you
P.S I use Xubuntu as O.S
Quoting Mohit Mundhra <address@hidden>:
> ok, please do so. I had USB working in one of my tiny boards but its not
> working now :( . I dont know what problem it is having. Do let me know all
> the steps
>
> thanks
>
> -
> mundhra
>
> On Sat, Jun 7, 2008 at 5:31 PM, C Kuo <address@hidden> wrote:
>
> > Hi there
> >
> > I was recently playing around Tiny1.1, so I may be able to help you.
> >
> > Have you upload the bootloader? if yes, then check with your USB wire
> > connection, are they connected well?
> >
> > I currently have 3 of tiny 1.1 working, so you if want, I can share all
> > the
> > step I have been taken to you.
> >
> >
> >
> >
> > Regards
> >
> >
> > Chen
> >
> >
> > Quoting Mohit Mundhra <address@hidden>:
> >
> > > I am unable to use the USB port on my tiny 1.1 board for uploading the
> > code
> > > to the board. It always gives the message:
> > >
> > > no USB device
> > > make[1]: *** [upload] Error 1
> > >
> > > Can you tell me what could be the problem?
> > >
> > > I am having the root permissions when I am trying to do this. So, there
> > is
> > > some other problem, may be with the hardware. I don't excatly know. The
> > rest
> > > of the board is working fine. Please suggest something
> > >
> > > --
> > > Mohit Mundhra
> > >
> >
> >
> >
> >
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> >
>