Re: [Openvortex-dev] Re: [Alsa-devel] Re: au88x0 modem

[Maarten Vanraes]

> Hello!
>
> On Wed, Sep 14, 2005 at 12:44:13AM +0300, Sasha Khapyorsky wrote:
>> On 19:49 Tue 13 Sep     , Philipp Matthias Hahn wrote:
>> > ACPI: PCI Interrupt 0000:00:06.0[A] -> Link [LNKC] -> GSI 10 (level,
>> low) -> IRQ 10
>> > Vortex: init.... <6>done.
>> > vortex: ac97 address never arrived
>> > AC'97 1 does not respond - RESET
>>
>> Understood. Could you send full 'lspci -vv' please.
>
> 0000:00:06.0 Multimedia audio controller: Aureal Semiconductor AU8810
> Vortex Digital Audio Processor (rev 03)
>       Subsystem: ASUSTeK Computer Inc.: Unknown device 1043
>       Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR- FastB2B-
>       Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
> <TAbort-
> <MAbort- >SERR- <PERR-
>       Interrupt: pin A routed to IRQ 10
>       Region 0: Memory at fedc0000 (32-bit, non-prefetchable) [size=256K]
>       Region 1: I/O ports at fce0 [size=8]
>       Region 2: I/O ports at fce8 [size=8]
>       Capabilities: [dc] Power Management version 2
>               Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA
> PME(D0-,D1-,D2+,D3hot+,D3cold+)
>               Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>

if it helps: mine is:

00:0c.0 Multimedia audio controller: Aureal Semiconductor AU8810 Vortex
Digital Audio Processor (rev 02)
        Subsystem: Aureal Semiconductor AU8810 Vortex Digital Audio Processor
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 64 (500ns min, 20750ns max), cache line size 40
        Interrupt: pin A routed to IRQ 169
        Region 0: Memory at 00000000fdc00000 (32-bit, non-prefetchable)
[size=256K]
        Region 1: I/O ports at dc00 [size=8]
        Region 2: I/O ports at cc00 [size=8]
        Capabilities: [dc] Power Management version 2
                Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=0mA
PME(D0-,D1-,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-