by the way,
the methode "5d" was kind of the good one, but not enough... You
can have a look at "src/suitesparse.mk" to see the full commands.
The idea is to replace "gcc" by "i686-pc-mingw32-gcc", "ld" by
"i686-pc-mingw32-ld", "ar" by "i686-pc-mingw32-ar" and
"pkg-config" by "i686-pc-mingw32-pkg-config" in every call to
those tools in the Makefile. Which could be achieved by doing :
make CC=$(CROSS)gcc LD=$(CROSS)ld AR=$(CROSS)ar PKG_CONFIG=$(CROSS)pkg-config ...
But please note that it is never enough!
good luck.
PS : you are very close to make a "fox-toolkit.mk" package that you could submit to MXE !
On 05/28/2013 04:19 PM, Niels Kristian Bech Jensen wrote:
> But, I think I need to cross compile the
UMFPACK too. So, I downloaded
> it and there is no shellscript file called "configure"
there. How do I
> proceed with this library?
Hi Ramon.
UMFPACK is part of SuiteSparse which is included in MXE. You do
not need to build it from scratch. Just do a 'make suitesparse'.
Best regards,
Niels Kristian Bech Jensen