[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Linphone-developers] [Embedded Linux] Cannot start thread

From: Pedro
Subject: Re: [Linphone-developers] [Embedded Linux] Cannot start thread
Date: Mon, 30 Jul 2018 21:09:11 -0300

Hi Russell, thanks for the tip!

Yes, it's really old, but belle-sip isn't in builroot yet (oficially). I've tried to add it bymyself, with no success. But good news, 3.6.1 is now working on my board! I can make and receive calls, but the problem now is with audio. I'm only hearing the call, no sound after the answer. I'm only using PCMA and PCMU codecs and even on Ubuntu can't make it work...

Thanks again!

2018-07-27 13:05 GMT-03:00 Russell Treleaven <address@hidden>:
Pedro that is really ancient.
The current version of linphone is 4.1.1 and uses the belle-sip sip stack.

Hope this helps.

On Thu, Jul 26, 2018 at 8:23 PM, Pedro <address@hidden> wrote:
Hey, hello!

I'm trying to use Linphone console on an embedded Linux (based on buildroot for ARM Cortex-A9), but I'm getting the log below:

ortp-message-getaddrinfo returned the following addresses:
ortp-message- port 5060
ortp-error-Error while creating a new thread
ortp-error-eXosip: Cannot start thread!
ortp-warning-Could not start udp transport on port 5060, maybe this port is already used.
Warning: Could not start udp transport on port 5060, maybe this port is already used.

It's not an "already used port" issue, as I changed it to various numbers... Does anyone knows what should be? I'm using the following packages versions:

linphone 3.6.1
libosip2 3.6.0
libeXosip2 3.6.0

Thanks a lot!

Linphone-developers mailing list


Russell Treleaven

Linphone-developers mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]