Re: Galileo E5a and E5b bands simultaneously receiver with GRC

[David Dima]

Hi Marcus,

Thank you for your very prompt response. I have changed that but it still does not work. Do you know if it is possible to separate the two bands after the UHD: USRP block?

David

El mar, 14 feb 2023 a las 16:54, Marcus Müller (<mueller@kit.edu>) escribió:

H David,

that makes no sense – from the figure, you would need to capture 50 MHz
of bandwidth. So, you will need at least that as sampling rate.

Your Bandwidth setting makes no sense, either, unless it's less than the
sampling rate (in general, just leave that field empty, and UHD will
choose an appropriate filter for your sampling rate).

So, that will have to change.

Best regards,
Marcus

On 2/14/23 16:30, David Dima wrote:
> Hello,
> I am trying to *record simultaneously *the Galileo IQ *E5a and E5b*
> signals with GNU Radio Companion (GRC) as follows:
>
>
>
> The UHD: USRP Source main parameters are set up as follows:
> - Sampling rate: 20.5Msps
> - Channel bandwidth: 50MHz
> - Central frequency: 1191.795MHz
> - Number of channels: 1 ( Since USRP 2190 model has only 1 local
> oscillator, it will not be possible to use 2 simultaneously channels
> for receiving)
>
> The IQ samples are stored in a file for further processing using a
> configuration file of the GNSS-SDR tool.
>
> I manage to process and read the E5a signal correctly, but it does not
> work for E5b. So I think the issue comes from the way I
> implemented the receiver in GRC.
>
> The question is, if it is necessary to do any intermediate processing
> of the signal in GRC to accomplish the aforementioned task.
>
> Many thanks in advance,
>
> David