|
From: | Lipski, Michael Victor |
Subject: | Re: Receiving on two channels with E310/E312 |
Date: | Wed, 27 Jul 2022 17:40:14 +0000 |
I tried both options; "A:A A:B" was invalid; it seems to accept "A:0 A:1", except that it gives me the same error message: "Runtime
Error: port number 1 exceeds max of 0."
From: Discuss-gnuradio <discuss-gnuradio-bounces+mvl5023=psu.edu@gnu.org> on behalf of Lipski, Michael Victor <mvl5023@psu.edu>
Sent: Wednesday, July 27, 2022 12:04 PM To: GNU Radio Mailing List <discuss-gnuradio@gnu.org> Subject: Receiving on two channels with E310/E312
Hello all,
I am running some simple tests with some E310/E312 radios and would like to set one up to receive on two channels simultaneously. How would I go about doing this using the UHD:USRP Source block? I have no problem receiving on a single channel, but when I
try to set up the block to have two channels, I get a, "Runtime Error: port number 1 exceeds max of 0."
I am rather new to the E310/E312, and I'm testing them out over networked mode rather than embedded. I have the device set up with a static IP address, which is configured in the Device Address box. What would be the basic parameters needed to set up an E310
to receive on two channels? I know the two RX channels would share the same LO, so I have the center frequency set to the same value for Ch0 and Ch1. I'm using
GRC 3.8 and UHD 4.1.0.
I appreciate any help with this. Thanks!
|
[Prev in Thread] | Current Thread | [Next in Thread] |