Hello all,
I am running some simple tests with some E310/E312 radios and
would like to set one up to receive on two channels
simultaneously. How would I go about doing this using the
UHD:USRP Source block? I have no problem receiving on a single
channel, but when I try to set up the block to have two
channels, I get a, "Runtime Error: port number 1 exceeds max of
0."
I am rather new to the E310/E312, and I'm testing them out over
networked mode rather than embedded. I have the device set up
with a static IP address, which is configured in the Device
Address box. What would be the basic parameters needed to set
up an E310 to receive on two channels? I know the two RX
channels would share the same LO, so I have the center
frequency set to the same value for Ch0 and Ch1. I'm using GRC 3.8 and
UHD 4.1.0.
I appreciate any help
with this. Thanks!
Make sure your SUBDEV spec is: