On 11/28/2012 06:09 PM, Alex Dusowitz wrote:
> Hi,
>
> Has anyone had any problem with setting up MIMO with USRP2? I am trying to
> replicate an N210 MIMO setup that I had a while ago and just replaced N210
> with 2 USRP2s. They are connected with a MIMO cable while one of them is
> connected with an ethernet cable to the host. Both devices are set with 2
> different IP addresses and I can ping both of them in the MIMO setup. But
> when I feed both USRP2s with a sine wave (coming from one source), my scope
> sink only shows the signal from one USRP2 (the slave one) and the other
> channel shows just noise. Is there any limitation for USRP2s in MIMO
> configuration?
>