[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] MIMO with USRP2
From: |
Josh Blum |
Subject: |
Re: [Discuss-gnuradio] MIMO with USRP2 |
Date: |
Wed, 28 Nov 2012 18:12:04 -0800 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:16.0) Gecko/20121028 Thunderbird/16.0.2 |
On 11/28/2012 06:09 PM, Alex Dusowitz wrote:
> Hi,
>
> Has anyone had any problem with setting up MIMO with USRP2? I am trying to
> replicate an N210 MIMO setup that I had a while ago and just replaced N210
> with 2 USRP2s. They are connected with a MIMO cable while one of them is
> connected with an ethernet cable to the host. Both devices are set with 2
> different IP addresses and I can ping both of them in the MIMO setup. But
> when I feed both USRP2s with a sine wave (coming from one source), my scope
> sink only shows the signal from one USRP2 (the slave one) and the other
> channel shows just noise. Is there any limitation for USRP2s in MIMO
> configuration?
>
It should work identically. Can you confirm that the devices work as
expected when used only in the *single* device case?
-josh
> Thanks,
> Alex
>
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>