|
From: | Patrik Tast |
Subject: | [Discuss-gnuradio] F14 GR traditional usrp install (no uhd) |
Date: | Sun, 15 May 2011 21:01:51 +0300 |
Hi all,
I really screwed up today when I upgraded from F13 to
F14 result, no network, access denied to every device (RAID),
etc.
I was able to burn (backup) sources to disk and then
formatted from latest F14.
I run into probs when installing the traditional USRP1
without uhd. Configure seems to expect sdcc v2 but the latest is
3.
Another observation, configure used to build both USRP1/2.
Now USRP2 seems to be the only availabel by default, that is
understandable.
Snips from terminal output:
./configure --enable-usrp --enable-gr-usrp
configure: Using LIBUSB version 'libusb'
checking for sdcc... sdcc -mmcs51 --no-xinit-opt checking for asx8051... no USRP requires sdcc version 2. sdcc not found. See http://sdcc.sf.net Unable to find firmware compiler SDCC. configure: error: Component usrp has errors; stopping. sdcc -v
SDCC : mcs51/gbz80/z80/ds390/pic16/pic14/TININative/ds400/hc08 3.0.0 #6037 (Mar 20 2011) (Linux) I suspect this is the problem, 2 vs 3?
Another snip from terminal
output: ./bootstrap./configure
config.status: executing depfiles
commands
********************************************************************* The following components were skipped either because you asked not to build them or they didn't pass configuration checks: usrp2-firmware
These components will not be built.
********************************************************************* The following GNU Radio components have been successfully configured: config
gruel volk gnuradio-core usrp2 gr-usrp2 gr-msdd6000 gr-audio gr-atsc gr-cvsd-vocoder gr-gsm-fr-vocoder gr-noaa gr-pager gr-radio-astronomy gr-trellis gr-video-sdl gr-wxgui gr-qtgui gnuradio-examples grc docs You my now run the make command to build these components.
*********************************************************************
The following components were skipped either because you asked not to build them or they didn't pass configuration checks: gcell
usrp gr-usrp gr-gcell gr-comedi gr-gpio gr-radar-mono gr-sounder gr-utils gr-uhd These components will not be built.
Configured GNU Radio release v3.4.0git-139-gf53fef3d for build.
Patrik
|
[Prev in Thread] | Current Thread | [Next in Thread] |