Re: [Discuss-gnuradio] USRP2 Ethernet link Issues

[Praveen Vikram]

Sorry for the late reply, just got into my lab.

When I start the USRP2, This is what happens:

F lights up first,

then all the LEDS flash

and D and F stay on.

I tried burning txrx_raw_eth_20100608.bin/u2_rev3-20100603.bin as my fw/fpga on the SD card and even that does the same thing.

I'am using the Kingston 2gb SD card I got with the USRP2.

Praveen

On Wed, Mar 30, 2011 at 10:07 PM, Josh Blum <address@hidden> wrote:

On 03/30/2011 07:01 PM, Praveen Vikram wrote:
> Thank you josh.
>
> I did not look into the firewall issues. I will check the firewall status
> and post back.
>
> Ping does not work since the gigabit interface doesn't even detect a link
> (as reported by ethtool).
>

Sorry, then its probably not a firewall issue.

To help you confirm that the right images are burned to the sd card. Can
you see that the lights blink in the following pattern (after power cycle):

1) E
2) E + C
3) E + C + A

then E, C, and A blink on and off twice

then D and F remain on

-josh