[Discuss-gnuradio] The (in)famous channel 0 not receiving error
From:
Nick Othieno
Subject:
[Discuss-gnuradio] The (in)famous channel 0 not receiving error
Date:
Wed, 12 Jan 2011 12:52:39 -0500
Hi everyone,
I recently compiled and installed gnuradio.
I then tried to find the usrp2:
#find_usrps 00:50:c2:85::3b:5c hw_rev = 0x0400
Next I tried to plot an FFT of the GPS L1 signal (note that my daughterboard is a dbsrx2)
#usrp2_fft.py -f 1.57542G usrp2: channel 0 not receiving usrp2::rx_samples() fail
Where am I going wrong? I have seen other posts with people facing the same problem but they are from way back in mid-2010 and with different daughterboards from mine.
Additional information: - daughterboard is a dbsrx2 - usrp2 was ordered sometime in October 2010 - I have the uhd driver installed but figured that it can exist with the "usual" Ethernet driver - Are there any firmware and/or fpga upgrades I am supposed to make?