qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [PATCH v5-resend 2/2] mips_fulong2e: Add on-board graph


From: BALATON Zoltan
Subject: Re: [Qemu-devel] [PATCH v5-resend 2/2] mips_fulong2e: Add on-board graphics chip
Date: Fri, 8 Mar 2019 17:22:06 +0100 (CET)
User-agent: Alpine 2.21.9999 (BSF 287 2018-06-16)

On Fri, 8 Mar 2019, Gerd Hoffmann wrote:
On Thu, Mar 07, 2019 at 01:32:41AM +0100, Philippe Mathieu-Daudé wrote:
On 3/6/19 9:05 PM, BALATON Zoltan wrote:
Add (partial) emulation of the on-board GPU of the machine. This
allows the PMON2000 firmware to run and should also work with Linux
console but probably not with X yet.

Signed-off-by: BALATON Zoltan <address@hidden>
Reviewed-by: Philippe Mathieu-Daudé <address@hidden>
Tested-by: Philippe Mathieu-Daudé <address@hidden>

Mojibaked again :(

Mail was sent without Content-Type: header.  Both mutt and "git am" on
my machine assume utf-8 and everything looks fine.  I guess your mail
client assumes something else ...

So it came out good at the end but that depends on what maintainer's config does by default it seems.

"git send-email" should send the patches with correct headers, it even
asks for the charset it should use in case it finds non-ascii
characters.  So BALATON, could you check your mail client config, or
switch over to "git send-email" for submitting patches?

I'm sending what git format-patch is generating and that does not add content type header by default. Is there a config option to enable that? I can't use git send-email because I'm sending from different machine than I use git on.

Regards,
BALATON Zoltan


reply via email to

[Prev in Thread] Current Thread [Next in Thread]