On Wed, Sep 29, 2010 at 09:59:55PM +0200, Stefan Weil wrote:
I reviewed the latest sources of Linux, FreeBSD and NetBSD.
They all reset the multiple IA bit (multi_ia in BSD) to zero,
but I did not find code which sets this bit to one
(like it is done by some routers).
Running Windows guests also did not set this bit.
Intel's Open Source Software Developer Manual does not
give much information on the semantics related to this bit,
so I had to guess how it works. The guess was good enough
to make the router emulation work.
Related changes in this patch:
* Update naming and documentation of the internal hash register.
It is not limited to multicast, but also used for multiple IA.
* Dump complete configuration register when debug traces are enabled.
* Debug output when multiple IA bit is set during CmdConfigure.
* Debug output when frames are received because multiple IA bit is set,
or when they are ignored although it is set.
Cc: Michael S. Tsirkin<address@hidden>
Signed-off-by: Stefan Weil<address@hidden>
---
hw/eepro100.c | 30 +++++++++++++++++++++---------
1 files changed, 21 insertions(+), 9 deletions(-)
diff --git a/hw/eepro100.c b/hw/eepro100.c
index 2b75c8f..5f6dcb6 100644
--- a/hw/eepro100.c
+++ b/hw/eepro100.c
@@ -219,7 +219,8 @@ typedef enum {
typedef struct {
PCIDevice dev;
- uint8_t mult[8]; /* multicast mask array */
+ /* Hash register (multicast mask array, multiple individual addresses). */
+ uint8_t mult[8];
Nitpick:
It seems to me like if mult is only used internally. If so, why not
represent the hash filter with an uint64_t?
Then you can replace the current memsets with ->mult = 0 and simplify
the match logic.