Hi Chris
We fly with ENABLE_AIR_START 1
A quick look at the code. My assumption:
If it is on, ArduIMU will take only the
ROLL_NEUTRAL_DEFAULT and
PITCH_NEUTRAL_DEFAULT
to offset the values.
Otherwise it will take the average of the firs 400 values to generate
an offeset.
I'm not sure about this, but we had many successfully flights with it
enabled.
Bruzzlee
On 20.05.2011 14:14, Chris wrote:
Hi.
I tried to use the "ins_arduimu_basic" files but after loading the
arduimu firmware to the board itself
there was no led flashing indicating initialization, only the yellow
light was steadily on.
Then i compared the older files with the new ones and i found that
"Airstart" was enabled where in the older ones it was disabled :
#define ENABLE_AIR_START 1 // 1 if using airstart/groundstart
signaling, 0 if not
After disabling it the initialization was performed as usual and the
imu was working.
I can't say if the IMU was working with airstart set to 1 despite the
fact that there was no
evidence of initialization since i forgot to check.
The IMU could be operational and just the leds did not flash, that's
why i am asking.
Is this the correct behavior when Airstart is enabled?
Should airstart be enabled to start with?
Chris
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel