|
From: | Chris |
Subject: | [Paparazzi-devel] Arduimu basic airstart enabled or not? |
Date: | Fri, 20 May 2011 15:14:37 +0300 |
User-agent: | Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.2.17) Gecko/20110424 Thunderbird/3.1.10 |
Hi.I tried to use the "ins_arduimu_basic" files but after loading the arduimu firmware to the board itself there was no led flashing indicating initialization, only the yellow light was steadily on. Then i compared the older files with the new ones and i found that "Airstart" was enabled where in the older ones it was disabled :
#define ENABLE_AIR_START 1 // 1 if using airstart/groundstart signaling, 0 if not
After disabling it the initialization was performed as usual and the imu was working. I can't say if the IMU was working with airstart set to 1 despite the fact that there was no
evidence of initialization since i forgot to check.The IMU could be operational and just the leds did not flash, that's why i am asking.
Is this the correct behavior when Airstart is enabled? Should airstart be enabled to start with? Chris
[Prev in Thread] | Current Thread | [Next in Thread] |