On Fri, 2005-09-16 at 23:47 +0200, elgrande wrote:
Yippieh, no error messages...
so far so good...
I now can load patches without problems...
But: No Sound....
I think I just do not understand it...
IT IS QUIET!
HELP!
Which patches are you loading? Are you connecting the JACK ports?
A simple way to check that Om itself is working: Create a new patch with
the name "sinepatch", add an audio output module ("Om patch audio output
node") with the name "audio_output_0", add a sine oscillator ("Sine
Oscillator (Freq:control, Amp:control)" ), connect the JACK port
"Om:sinepatch/audio_output_0" to the JACK port for your soundcard using
qjackctl or Patchage or jack_connect, connect the output of the sine
oscillator to the "audio_output_0" module in your Om patch. You should
hear a beep, if you don't something is wrong with Om or your audio
setup.
------------------------------------------------------------------------
_______________________________________________
Om-synth mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/om-synth