[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: crashing octave with copy command in editor

From: Dmitri A. Sergatskov
Subject: Re: crashing octave with copy command in editor
Date: Wed, 9 Jan 2019 15:55:33 -0600

On Wed, Jan 9, 2019 at 10:54 AM Doug Stewart <address@hidden> wrote:

I tried bisecting and the problem disappeared! on both machines!
I think that if you start a completely fresh build on a fresh mach. then it will fail but when you recompile the problem disappears.

DASCertificate for 206392

I just build
HG ID for this build is "4d6392c879d7"
and again observed that the very first run terminates with signal 6 after that it runs fine:

Octave successfully built.  Now choose from the following:
   ./run-octave    - to run in place to test before installing
   make check      - to run the tests
   make install    - to install (PREFIX=/usr/local)
   HG ID for this build is "4d6392c879d7"
make[2]: Leaving directory '/home/dima/src/octave/gcc_def'
make[1]: Leaving directory '/home/dima/src/octave/gcc_def'
$ ./run-octave --gui
octave exited with signal 6
$ ./run-octave --gui
(runs fine)

In logs I see:

abrt-notification[9721]: Process 9544 (lt-octave-gui) crashed in malloc()



reply via email to

[Prev in Thread] Current Thread [Next in Thread]