Re: Showing instrument name and correct clef with cue notes

[Simon Bailey]

hi,

i remembered that there was an instrumentCueName property defined at  
some point, and have extended the solution a bit more.

On Feb 15, 2008, at 9:57 AM, Simon Bailey wrote:
<<<
tec = { \once \override Staff.Clef #'font-size = #-3 \clef tenor }
bc = { \once \override Staff.Clef #'font-size = #-3 \clef bass }
%% Trombone 3 preQuote setup
tIIIpq = {
 \set fontSize = #-3
 \bc
 \set Voice.instrumentCueName = "Trbn. III"
}


second = \relative c' {
[...]
\tag #'cued { \cueDuring #"trbnIIIquote" #1
  { \tIIIpq R1*3 \tec }}
\tag #'uncued { R1*3 }
[...]
}

trbnIIscore = \keepWithTag #'uncued \second
trbnII = \simultaneous {
         \new Voice = "cue" { \voiceOne \smaller \skip 1*58 }
         \new Voice \keepWithTag #'cued \second
}
>>>

the rest stays the same.

you could probably create a scheme function that takes 4 parameters,  
quoteClef, originalClef, instrumentCueName and music and just use that  
in the music block of the \cueDuring command, resulting in something  
like:

\tag #'cued { \cueDuring #"trbnIIIquote" #1 { \quoteMe #"bass"  
#"tenor" #"Trbn. 3" {R1*3} } }
\tage #'uncued { R1*3 }

which would mean you wouldn't have to define a preQuote command for  
each instrument you're using.

hope that helps, regards,
sb
--
Simon Bailey
Systems Administrator
Institut fuer Informatik
Universitaet Innsbruck
Technikerstrasse 21a/2
A-6020 Innsbruck
Tel: +43 (0) 512 507 - 6433
Mob: +43 (0) 664 812 5267
Fax: +43 (0) 512 507 - 2887
http://informatik.uibk.ac.at/