Re: unzoom problem

[Martin Helm]

Am Freitag, 29. Oktober 2010, 13:28:23 schrieb Martin Helm:
> Am Freitag, 29. Oktober 2010, 11:11:26 schrieb Paolo Buratti:
> > Good morning,
> > I have a problem with unzooming plots with octave 3.2.4 on windows xp
> > (installer: Octave-3.2.4_i686-pc-mingw32_gcc-4.4.0_setup).
> > I can zoom by two right clicks that define a rectangle, followed by
> > one left click, but, after that, if I try to unzoom by typing 'a', the
> > figure becomes "not responding" and I have to throw it away.
> > If I make a figure directly by WGnuplot (the version which was
> > installed by the same octave installer), the unzoom by 'a' works well.
> > In addition to having unzoom ok, the figure layout produced by
> > WGnuplot differs from the one by octave: there is an extra bar with
> > command icons.
> > I have found a similar question on mouse zoom/unzoom in the octave
> > mail archive (18.08.2010), but I could not find any answer with a
> > suggeted fix (the answer on 23/08 only asks what is the operating
> > system).
> > Thank you in advance
> > Paolo Buratti
> > _______________________________________________
> > Help-octave mailing list
> > address@hidden
> > https://www-old.cae.wisc.edu/mailman/listinfo/help-octave
> 
> I see that the question about the operating system from 23.8.2010 was from
> me. But never got an answer.
> 
> So here I see you are using windows. Probably you have trouble with the
> oct2mat package. Can you check the following:
> 
> start octave and then type
> 
> pkg list
> 
> if you see in that list a package named oct2mat and it has an astrisk *
> which tells you that it is loaded do the following
> 
> pkg -rebuild noauto oct2mat
> 
> exit octave and start it again and see if the problem is still there.

Oops sorry I had a type the command is
pkg rebuild -noauto oct2mat