[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Measuring RSSI values using GRC
From: |
Naceur |
Subject: |
[Discuss-gnuradio] Measuring RSSI values using GRC |
Date: |
Fri, 15 Nov 2013 13:41:31 -0800 (PST) |
Hello GR list,
I am intending to read RSSI values on a RX (USRP N210),
I have found in the post of Marcus D. Leech in
https://www.ruby-forum.com/topic/1857766
10*LOG10(DECIMATE(SINGLE_POLE_IIR_FILTER(COMPLEX_TO_MAG**2(SIGNAL))))
Using GRC, I tried to implement that method of calculation as shown in the
attached figure,
1/ Is the flowgraph correct, or is there any missing block (decimation) ?
2/ Then how can I read in human readable format (ASCII) the RSSI values from
the test_RSSI.txt file sink ?
3/ Is there a way to command the duration of execution of the flowgraph
within GRC () ?
4/ How can I format the test_RSSI.txt file sink to obtain single RSSI values
per line ?
Any explanations are welcome,
Regards,
Naceur
--
View this message in context:
http://gnuradio.4.n7.nabble.com/Measuring-RSSI-values-using-GRC-tp44749.html
Sent from the GnuRadio mailing list archive at Nabble.com.
- [Discuss-gnuradio] Measuring RSSI values using GRC,
Naceur <=