[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] UHD + USRP2 + WBX doubt
From: |
skcruser |
Subject: |
Re: [Discuss-gnuradio] UHD + USRP2 + WBX doubt |
Date: |
Fri, 9 Sep 2011 00:10:45 -0700 (PDT) |
sumitstop wrote:
>
>>> http://www.youtube.com/watch?v=REDK7M-83WQ
> i had seen that video sumit..in tht LED B turns on in the end rite...
> in my case it was not turning on..so i got worried
> now i knw tht it turns on only when mimo cable is being used
>
>>> uhd_fft.py receives the signal from the specified range and shows its
>>> spectrum... hence led C turns on which that indicates usrp2 is
>>> receiving.
>
> hmm...it was not turning on when i was using raw ethernet drivers...so the
> concern
>
> now i guess theres nothing to worry abt...thanx man
>
>
> skcruser wrote:
>>
>> I am using the WBX daughterboard with USRP2 interfaced using the UHD
>> Driver.
>>
>> The LED boot sequence is as follows
>> 1. F turns on
>> 2. E, C, A turn on and then blink and turn off
>> 3. D turns on
>>
>> is the above sequence correct? (B never turns on)
>>
>> also when I run uhd_fft.py, led C turns ON. is it normal or shud i be
>> worried?
>>
>> PS - what is the significance of each LED??
>>
>
>
--
View this message in context:
http://old.nabble.com/UHD-%2B-USRP2-%2B-WBX-doubt-tp32428919p32429354.html
Sent from the GnuRadio mailing list archive at Nabble.com.