[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] USRP2 missing Quadrature samples
From: |
Eric Blossom |
Subject: |
Re: [Discuss-gnuradio] USRP2 missing Quadrature samples |
Date: |
Fri, 30 Jan 2009 16:41:44 -0800 |
User-agent: |
Mutt/1.5.18 (2008-05-17) |
On Fri, Jan 30, 2009 at 04:24:55PM -0800, Leslie Choong wrote:
> So I've pulled down the most recent trunk and re-built gnuradio. One
> thing I noticed that I forgot about was that running make in
> gnuradio/usrp2 does not produce a txrx.bin under usrp2/firmware/apps.
> I must have copied the latest one sitting in the trunk which is dated
> Dec 31st (same date as the FPGA binary blob).
>
> I looked into it and it seems like ./configure did not find mb-gcc
> (the microblaze toolchain). I installed the pre-compiled binary from
> instructions here:
> http://gnuradio.org/trac/wiki/USRP2UserFAQ
>
> And then after configuring and running make I get this error:
> make[3]: Entering directory `/home/leslie/gnuradio/usrp2/firmware/lib'
> if gcc -DHAVE_CONFIG_H -I. -I. -I.. -DHAL_IO_USES_UART -I../include
> -I../lib --std=gnu99 -Wall -Werror-implicit-function-declaration
> -mxl-soft-div -msoft-float -mxl-soft-mul -mxl-barrel-shift -g -O2 -MT
> abort.o -MD -MP -MF ".deps/abort.Tpo" -c -o abort.o abort.c; \
> then mv -f ".deps/abort.Tpo" ".deps/abort.Po"; else rm -f
> ".deps/abort.Tpo"; exit 1; fi
> cc1: error: unrecognized command line option "-mxl-soft-div"
> cc1: error: unrecognized command line option "-mxl-soft-mul"
> cc1: error: unrecognized command line option "-mxl-barrel-shift"
> make[3]: *** [abort.o] Error 1
Run ./configure from top directory. Otherwise you get gcc instead of mb-gcc.
Eric