[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] USRP Audio Rate versus Sample Rate of Soundcard
From: |
meggahertz |
Subject: |
[Discuss-gnuradio] USRP Audio Rate versus Sample Rate of Soundcard |
Date: |
Tue, 12 Feb 2008 21:33:11 -0500 |
Hello!
I am current transmitting an audio stream from my sound card (SB Audigy2) to
the USRP and it is transmitting at an FM frequency. The problem I am facing is
that my sound card supports 44100Hz sample rate however, since the USRP audio
rate is an integer factor of 128MS/s When I receive the signal on a regular FM
radio it sounds funny depending on the audio rate I set (either sounds high
pitched if i set audio rate to high or sounds low pitched and slow if I choose
a lower sample rate).
If I change the sample rate for the audio_source (sound card) it gives me an
error that the sound card requests 44100Hz.
I am including the lines I am using to rectrieve the audio data:
" self.fg = gr.flow_graph()
src = audio.source(44100, options.audio_input)
fmtx = blks.wfm_tx(self.fg, self.audio_rate, self.usrp_rate)
self.fg.connect(src, fmtx, gain, self.u)"
Thank you for the previous help and Thanks for this one in advance.
Omer
--
This message was sent on behalf of address@hidden at openSubscriber.com
http://www.opensubscriber.com/messages/address@hidden/topic.html
- [Discuss-gnuradio] USRP Audio Rate versus Sample Rate of Soundcard,
meggahertz <=