[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Problem: Accessing RX-B of the basic Rx daughterb

From: Karthik Vijayraghavan
Subject: Re: [Discuss-gnuradio] Problem: Accessing RX-B of the basic Rx daughterboard
Date: Mon, 11 Feb 2008 23:45:52 -0800


Ah this is exactly what I have been grappling with as well. Basically
you need to set the MUX _such that_ you can access the two setting
simultaneously. If you have the gnuradio source you, look at the file
gnuradio-examples/multi-antenna/multi_scope.py which tells you how you
can look at 4 signals at the same time using two BASIC-RX boards.For
more than one signal, you can no longer use the
usrp.determine_rx_mux_value(u,rx_subdev_spec) method. Instead you have
to set the MUX by hand. The crucial line in the example code is.


This sets all the Q channels to zero (because of 0xf) and routes ADC0
to I0, ADC1 to I1 etc. To separate them  you have the line


I have yet to try this out on my own program, but that is as far as I
understand it. I believe If you want to get 4 signals simultaneously
you need load a special FPGA image file, the details of which are
shown in the example. However for getting only 2 signals the standard
FGPA config is good enough (there is an earlier post on this somewhere
in the archive). Maybe others can correct me if I am wrong.


On Feb 11, 2008 9:05 PM, Jason Anders <address@hidden> wrote:
> Hi! Thanks for your reply. It was helpful!
>  However, I have another follow-up question. So, basically I won't be able
> to access RX-A and RX-B simultaneously since I have to set the MUX
> everytime? Is this correct?
>  Thanks!


reply via email to

[Prev in Thread] Current Thread [Next in Thread]