Re: [Discuss-gnuradio] Using USRP w/o Daughterboard's

[Eric Blossom]

On Mon, Nov 07, 2005 at 04:40:29PM -0700, Robitaille, Michael wrote:
> >On Sat, Nov 05, 2005 at 05:50:17PM -0700, Robitaille, Michael wrote:
> 
> >> The problem is that the software needs to see the eeprom on the 
> >> daughterboard that I don't have and really don't need.
>
> 
> On Sun, 6 Nov 2005 08:54:21 -0800, Eric Blossom wrote:
> 
> > The code that's been in CVS for quite a while treats "no rx daughterboard"
> as if there were a Basic Rx
> 
> > daughterboard attached.
> 
> > See the last few lines for db_basic.py
> 
> Should I get the error message;
> 
>  "Warning: Treating daughterboard with invalid EEPROM contents as if it were
> a "Basic RX."
> "Warning: This is almost certainly wrong... Use appropriate burn-*-eeprom
> utility."

Have you tried to butch in a EEPROM to simulate a Basic Rx?  
If so, either program it, or remove it.

On the other hand, you may have hosed up something while modifying
your USRP motherboard.

> per the code in the last few line of db_basic.py?
> 
> I do not get this message when I run usrp_fft.py -R a:0
>
> Mike

Eric