[avrdude-dev] Adding support for ATmega32C1 in avrdude.conf

[Stuart Cording]

Hi All,

I am trying to add support for the ATmgea32C1 in avrdude.conf. My key aim
is to support this MCU (and some others later) to be programmed using the
Arduino IDE.

It isn't clear to me how to correctly add a new entry for an MCU that was
never supported by the STK500 and for which I can't find any "XML" files in
the Atmel Studio 6 install.

The items that are obvious for me (id, desc, signature etc.) I have
implemented, and AVRDUDE seems to accept that the part exists (it didn't
before, complaining that the device wasn't in the database of parts).
However, I haven't managed test actually programming a part yet.

Would someone be willing to either:
a) Explain which parameters I must have to support Arduino programming of
this MCU
OR
b) Check my new entry in the avrdude.conf to tell me if it is correct?

Many thanks in advance, Stuart