Re: [Qemu-discuss] Host-Bridge in routed TAP Mode

[Sven Gehr]

Am Freitag, 27. September 2013, 09:34:42 schrieb Vlad Yasevich:
> On 09/27/2013 08:54 AM, Sven Gehr wrote:
> > Am Donnerstag, 26. September 2013, 13:01:06 schrieb Vlad Yasevich:

> >> I think what you want to do is run:
> >>    virsh iface-bridge eth0 br0
> > 
> > ok, I try:
> > 
> > virsh iface-bridge eth0 intern
> > 
> > and get the error:
> > 
> > Error: faild to get interface 'eth0'
> > Error: this function is not supportet by the connection driver:
> > virtInterfaceLookupByName



> What does virsh iface-list show?

same error:
Error: faild to list active interfaces
 Error: this function is not supportet by the connection driver: 
virtInterfaceLookupByName



> If it doesn't show eth0, that
> means eth0 is already configured and probably managed by NetworkManager.
> Bring eth0 down and see if iface-list shows it.

Network-Manager is not installed. I remove the eth0-config in 
/etc/network/interfaces

This now looks like:

# The loopback network interface
auto lo
iface lo inet loopback


how do I configure eth0 in /etc/network/interfaces so that I can then define 
the bridge with libvirt (with eth0)?



-- 
Viele Grüsse

Sven Gehr
77815 Bühl