qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[PULL 20/24] virtio-mmio: Clear v2 transport state on soft reset


From: Michael S. Tsirkin
Subject: [PULL 20/24] virtio-mmio: Clear v2 transport state on soft reset
Date: Thu, 19 Dec 2019 08:28:41 -0500

From: Jean-Philippe Brucker <address@hidden>

At the moment when the guest writes a status of 0, we only reset the
virtio core state but not the virtio-mmio state. The virtio-mmio
specification says (v1.1 cs01, 4.2.2.1 Device Requirements:
MMIO Device Register Layout):

    Upon reset, the device MUST clear all bits in InterruptStatus and
    ready bits in the QueueReady register for all queues in the device.

The core already takes care of InterruptStatus by clearing isr, but we
still need to clear QueueReady.

It would be tempting to clean all registers, but since the specification
doesn't say anything more, guests could rely on the registers keeping
their state across reset. Linux for example, relies on this for
GuestPageSize in the legacy MMIO tranport.

Fixes: 44e687a4d9ab ("virtio-mmio: implement modern (v2) personality 
(virtio-1)")
Signed-off-by: Jean-Philippe Brucker <address@hidden>
Message-Id: <address@hidden>
Reviewed-by: Sergio Lopez <address@hidden>
Reviewed-by: Michael S. Tsirkin <address@hidden>
Signed-off-by: Michael S. Tsirkin <address@hidden>
---
 hw/virtio/virtio-mmio.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/hw/virtio/virtio-mmio.c b/hw/virtio/virtio-mmio.c
index 94d934c44b..ef40b7a9b2 100644
--- a/hw/virtio/virtio-mmio.c
+++ b/hw/virtio/virtio-mmio.c
@@ -65,6 +65,19 @@ static void virtio_mmio_stop_ioeventfd(VirtIOMMIOProxy 
*proxy)
     virtio_bus_stop_ioeventfd(&proxy->bus);
 }
 
+static void virtio_mmio_soft_reset(VirtIOMMIOProxy *proxy)
+{
+    int i;
+
+    if (proxy->legacy) {
+        return;
+    }
+
+    for (i = 0; i < VIRTIO_QUEUE_MAX; i++) {
+        proxy->vqs[i].enabled = 0;
+    }
+}
+
 static uint64_t virtio_mmio_read(void *opaque, hwaddr offset, unsigned size)
 {
     VirtIOMMIOProxy *proxy = (VirtIOMMIOProxy *)opaque;
@@ -378,6 +391,7 @@ static void virtio_mmio_write(void *opaque, hwaddr offset, 
uint64_t value,
 
         if (vdev->status == 0) {
             virtio_reset(vdev);
+            virtio_mmio_soft_reset(proxy);
         }
         break;
     case VIRTIO_MMIO_QUEUE_DESC_LOW:
-- 
MST




reply via email to

[Prev in Thread] Current Thread [Next in Thread]